SD-2WT
is a two-wire smoke detector that uses both photoelectric technology and a fixed-temperature heat sensor for enhanced detection capabilities. It is designed for use in commercial, industrial, and residential settings and can be connected to compatible fire alarm control units. An LED output model, the SD-2WT-LED, is also available.
Description
Description
is a two-wire smoke detector that uses both photoelectric technology and a fixed-temperature heat sensor for enhanced detection capabilities. It is designed for use in commercial, industrial, and residential settings and can be connected to compatible fire alarm control units. An LED output model, the SD-2WT-LED, is also available.
Related products
MBG914
Conventional fire alarm manual call point that is surface-mounted and used for fire emergency signaling. It is red, features a break-glass design with a protective film on the glass, and is easy to install. Key features include a high-visibility status LED, compatibility with Menvier conventional fire panels, and an included test key for maintenance.
SD1+
Auto dailer is a security system speech dialler that connects to an alarm control panel and automatically dials up to four phone numbers to deliver pre-recorded voice messages when an alarm is triggered. It features four inputs for different alarm conditions (like fire, burglary, or personal attack), has a built-in microphone and speaker for message recording, and allows the recipient to acknowledge the call by pressing '8' on their phone
UCHR-2W
Is a 2-wire conventional fire detector that combines both rate-of-rise and fixed heat detection. It is designed to respond to a rapid increase in temperature and/or temperatures exceeding a threshold of \(135^{\circ }F\) (\(60^{\circ }C\)), making it suitable for environments where smoke detectors may cause false alarms, such as those with high levels of dust or steam.
ULMCIM-C
Is a compact, soft-addressed single-channel input module for Eaton intelligent addressable fire alarm systems that monitors non-addressable, dry contact devices like water flow switches or auxiliary fault signals. The "-C" variant is specifically designed for use with pull stations and is identified by the panel as a callpoint. It features an integral short circuit isolator and can be easily installed inside other equipment.
ULMCOM-S
Is a compact, UL-listed single-channel output unit for Eaton's addressable fire alarm systems, which is identified by the panel as a sounder. It is used to control low-voltage devices by switching them, such as for fire door closures or plant shutdown circuits. The "S" designation signifies its primary use as a sounder, and it features easy, "plug and play" installation with no hard addressing required.