NC941/SS
Single zone call controller, s/steel
c/w 12V 250mA PSU & reset button
Related products
EFBW2ZFLEXI
Is a two-zone fire alarm control panel that uniquely combines both two-wire and conventional wiring technologies. This means each zone can be individually configured to operate as either a two-wire or a conventional system, allowing for a flexible mix of both types of devices on the same panel. It features an intuitive interface for straightforward programming and maintenance and meets the EN54 parts 2 and 4 standards.
MASB860
Intelligent, addressable wall-mounted sounder beacon for use in fire alarm systems that combines an audible sounder and a visual LED beacon for emergency evacuation signals. It is designed for low current consumption while providing high sound output and features a built-in short-circuit isolator and soft-addressing for easy installation. There is also a weatherproof (WP) version, the MASB860WP, with an IP66 rating for outdoor use.
MBG914
Conventional fire alarm manual call point that is surface-mounted and used for fire emergency signaling. It is red, features a break-glass design with a protective film on the glass, and is easy to install. Key features include a high-visibility status LED, compatibility with Menvier conventional fire panels, and an included test key for maintenance.
UCHR-2W
Is a 2-wire conventional fire detector that combines both rate-of-rise and fixed heat detection. It is designed to respond to a rapid increase in temperature and/or temperatures exceeding a threshold of \(135^{\circ }F\) (\(60^{\circ }C\)), making it suitable for environments where smoke detectors may cause false alarms, such as those with high levels of dust or steam.
ULCAH330
Addressable heat detector Rate of rise with fixed heat sensor settings will detect a rapid increase in temperature or temperatures above 135°F, and should be used in environments where the ambient conditions might cause false alarms if smoke detection were to be used, for example where there is a high level of dust, fumes, steam or smoke under normal conditions.
ULMCIM-C
Is a compact, soft-addressed single-channel input module for Eaton intelligent addressable fire alarm systems that monitors non-addressable, dry contact devices like water flow switches or auxiliary fault signals. The "-C" variant is specifically designed for use with pull stations and is identified by the panel as a callpoint. It features an integral short circuit isolator and can be easily installed inside other equipment.